Metrohm tiamo 2.4 Manual - Manual (Page 1021)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1005
Identifica-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has not ever been started
.DBL Total duration for the processing of the command in s
.EGF Last measured gas flow rate (measured value following
processing of the command) in mL/min
.EME Final measured value (measured value after processing
of the command) in the unit of the measured value
.FIN Command status; 1 = Command has been ended
at least once, 0, invalid (variable not available) =
Command has never been ended
.GMA Maximum gas flow rate in mL/min
.GMI Minimum gas flow rate in mL/min
.GMN Average gas flow rate in mL/min
.IGF Initial gas flow (measured value at the time of the start
of the command) in mL/min
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.LP.CAx Calculated value × (1...3) for the last measuring point
of the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.GFL Gas flow value for the last measuring point of the
measuring point list in mL/min
.LP.MEA Measured value (temperature) for the last measuring
point of the measuring point list in the unit of the
measured value
.LP.TEM Temperature for the last measuring point of the mea-
suring point list in °C
.LP.TIM Time in s until the last measuring point of the measur-
ing point list is reached
.MA.MEA Maximum measured value (temperature) in the unit of
the measured value