Metrohm tiamo 2.4 Manual - Manual (Page 908)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
892 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identification Description
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used
for the command
.DBL Total duration for the processing of the command in
s
.DSC Time for processing all start conditions in s
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.ENP Electrode zero point of the sensor used for the com-
mand (in mV for ISE sensors)
.ETE End temperature (temperature after the command
has been processed) in °C
.EVT End volume (total dosed volume at the end of the
command) in mL
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
.FP{x}.MEA Measured value for the fixed endpoint × (1 - 9) in mV
.FP{x}.TEM Temperature for the fixed endpoint × (1 - 9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1 - 9) is reached
.FP{x}.VOL Volume for the fixed endpoint × (1 - 9) in mL
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start condi-
tions are processed) in °C
.LP.CAx Calculated value × (1 - 3) for the last measuring point
in the measuring point list
.LP.DVT dV/dt for the last measuring point in the measuring
point list (SET, KFT, STAT, DOS) or drift for the last
measuring point in the measuring point list in µg/min
(KFC)
.LP.EXx External value × (1 - 3) for the last measuring point in
the measuring point list