Metrohm tiamo 2.4 Manual User Manual
Page 1037
■■■■■■■■■■■■■■■■■■■■■■
5 Method
tiamo 2.4
■■■■■■■■
1021
Selection
712 Conductometer | 856 Conductivity Mod-
ule
Default value
856 Conductivity Module
Sensor
Sensor
Selection of a sensor of the Conductivity sensor type from the sensors
configured in the sensor table.
Selection
Sensor name | Conductivity sensor
Default value
Conductivity sensor
Temperature measurement
Type of temperature measurement:
856
Selection
continuous | automatic | off
Default value
automatic
continuous
A temperature sensor must be connected. The temperature will then
be measured continuously.
automatic
If a temperature sensor is connected then the temperature will be
measured continuously. Otherwise, the temperature entered manually
under Temperature on the Measuring parameters tab will be
used.
off
The temperature will not be measured. The temperature entered man-
ually under Temperature on the Measuring parameters tab will be
used.
Stirrer
NOTE
Is displayed only if the 856 Conductivity Module has been selected as
device type.
Stirrer
Selection of the stirrer.
Selection
1 | 2 | 3 | 4 | off
Default value
1