Metrohm tiamo 2.4 Manual - Manual (Page 1132)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1116 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identifi-
cation Description
.ENP Electrode zero point calculated from the calibration
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended
.LCO Loop counter = current number of completed runs, both
of Repeat loops and of While loops
.LST Start time of the loop command (Date/Time)
.SLO Electrode slope calculated from the calibration
.VAR Variance of the calculated result of the calibration in the
selected unit
5.6.5.6.2 CAL LOOP Conc - Properties
Dialog window: Method ▶ CAL LOOP Conc ▶ Properties... ▶ CAL LOOP Conc -
'Command name'
The number of standards and their concentration are defined in the CAL
LOOP Conc - 'Command name' dialog window.
Command name
Name of the command.
Entry 25 characters
Standards
Number of standards
Selection of the number of standards with which the concentration cali-
bration is to be carried out.
Selection 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9
Default value 2
Unit conc.
Selection of the concentration unit for the standards.
Selection mol/L | mmol/L | µmol/L | g/L | mg/L | µg/L |
mg/mL | µg/mL | ppm | % | mEq/L
Default value ppm
Conc. standard #
Enter the corresponding concentration for each standard used.
Input range 0.001 - 999,999.999