Metrohm tiamo 2.4 Manual - Manual (Page 1148)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1132 ￭￭￭￭￭￭￭￭
tiamo 2.4
Devices
This command can be executed with the following instruments:
Spectrometer: Avantes
NOTE
In a one-channel instrument setup, only instruments for which the entry
not defined is selected under Instrument for reference channel in
the configuration can be selected.
In a two-channel instrument setup, only instruments which are assigned
an instrument for the reference channel can be selected (see Chapter
7.14.3, page 1559).
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the CAL MEAS Opt command are set on the follow-
ing two tabs:
￭ General/Hardware
Selection of instrument type and colorimetric sensor.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Command variables
The following command variables are generated by the CAL MEAS Opt
command in the method run and can be used in formulas under the des-
ignation 'Command name.Variable identification':
Identifica-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.DBL Total duration for the processing of the command in s