Metrohm tiamo 2.4 Manual - Manual (Page 1424)

6.7 Sensors subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1408 ￭￭￭￭￭￭￭￭
tiamo 2.4
Next calibration
Date on which the next calibration is to be carried out. The date can be
selected by clicking on in the Select date dialog window (see Chap-
ter 2.5.1, page 90). After the date has been entered, the value for Cali-
bration interval will be automatically adjusted.
Only editable if monitoring is switched on.
Default value
Calibration date+ 999 days
Message
The message options can only be edited if monitoring is switched on.
Message by e-mail
on | off (Default value: off)
If this option is enabled, the message is sent to the address defined under
[E-mail]. The message is sent in text format.
[E-mail...]
[E-mail...] opens the Send e-mail window (see Chapter 2.6.1, page 93).
Acoustic signal
on | off (Default value: off)
If this option is enabled, an acoustic signal will be emitted in addition to
the message defined above.
Action
The actions can only be edited if monitoring is switched on.
If during calibration monitoring it is found that its validity has expired then
one of the following actions will be triggered automatically during the
start test:
Selection Record message | Display message | Cancel
determination
Default value Display message
Record message
The message that the validity of the calibration has expired will be
automatically saved with the determination.
Display message
A message is displayed and you can select whether you want to con-
tinue the run or cancel it. If the run is continued, then the message
that the validity of the calibration has expired will be saved automati-
cally with the determination.