Metrohm tiamo 2.4 Manual - Manual (Page 1239)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1223
Parameters
The parameters for the command LIFT are configured in the following
dialog window:
￭ LIFT - Properties
Command variables
The following command variables are generated in the method run by the
command LIFT and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
.LPO Current absolute lift position in mm (entry when ending
the command)
5.6.7.4.2 LIFT - Properties
Dialog window: Method ▶ LIFT ▶ Properties... ▶ LIFT - 'Command name'
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.