Metrohm tiamo 2.4 Manual - Manual (Page 380)

4.7 Subwindow Results
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
364 ￭￭￭￭￭￭￭￭
tiamo 2.4
4.7 Subwindow Results
4.7.1 Results - General
Subwindow: Database ▶ Results
In the subwindow Results in the program part Database the results cal-
culated in the calculation commands and the variables used for are
shown. It shows the results overview, the raw data of the commands with
evaluations as well as the results calculated in the calculation commands,
statistical evaluations, formulas and all variables used for for the determi-
nation selected in the determination overview.
When navigating in the determination overview this data will be updated
automatically (with a certain delay).
The subwindow Results can be switched on and made visible in the defi-
nition of the layout in the program part Database. It can be enlarged and
reduced as required; it can also be maximized.
Tabs
The results of the determination are shown on the following tabs:
￭ Results overview
Shows the results overview for all calculation commands.
￭ Raw data
Display of evaluation raw data for commands with evaluations.
￭ "Command name"
Show the results for a single calculation command. A tab with the cor-
responding command name is provided for each calculation command.
4.7.2 Results - Results overview
Tab: Database ▶ Result ▶ Results overview
On the tab Results overview the results for all calculation commands
and (if existent and desired) the corresponding statistical evaluations are
displayed. The display of the statistical evaluations can be selected in the
dialog window Properties result window
Command "Command name"
For each CALC command a results overview is shown according to the
following pattern:
"Command name"
Name of the CALC command.