Metrohm tiamo 2.4 Manual - Manual (Page 1085)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1069
Selection 089 Photometer
Default value 089 Photometer
Sensor
Temperature measurement
Type of temperature measurement.
Selection continuous | off
continuous
The temperature will be measured continuously.
off
The temperature will not be measured. The temperature entered man-
ually under Temperature on the Measuring parameters tab will be
used.
Stirrer
Stirrer
Selection of the stirrer.
Selection 1 | off
Default value 1
off
Means that no stirrer will be used.
Stirring rate
Setting the stirring rate.
Input range 0 - 15
Default value 5
Switch off automatically
on | off (Default value: on)
If this check box is activated, the stirrer will be switched off automatically
when the command has finished.
5.6.4.16.3 MEAS TMF - Measuring parameters
Tab: Method ▶ MEAS TMF ▶ Properties… ▶ Measuring parameters
Command name
Name of the command.
Entry 25 characters