Metrohm tiamo 2.4 Manual - Manual (Page 163)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Workplace
tiamo 2.4
￭￭￭￭￭￭￭￭ 147
Stop series (shortcut: Ctrl S)
Immediate stop of the running determination (or the conditioning) of a
sample series. This button is present in the status BUSY (determination is
running), COND READY (condition requirement fulfilled) and COND
BUSY (conditioning is running), i.e. when conditioning has been started.
Interrupt run
Interrupts the ongoing determination of a sample series. The button is
enabled (dark gray) in the status BUSY (determination is running), COND
READY (condition requirement fulfilled) and COND BUSY (conditioning
is running). The button is disabled (light gray) in all other cases. When
[Hold] is pressed, it will be replaced in the display by [Cont].
Continue run
Continue the ongoing determination of a sample series. The button is
present only in the status HOLD (determination interrupted) and COND
HOLD (conditioning interrupted). Pressing [Cont] will cause this button to
be replaced again in the display by [Hold].
Interrupt series
With this button, the ongoing determination of a sample series will still be
carried out to completion but no new determination will be started. The
button is present in the status BUSY (determination is running). The but-
ton is disabled (light gray) in all other cases. When [Pause] is pressed, this
button will be replaced in the display by [Cont].
Continue series
Start of the next determination of an interrupted sample series. The but-
ton is only present in the status HOLD (series interrupted). Pressing [Cont]
will cause this button to be replaced again in the display by [Pause].