Metrohm tiamo 2.4 Manual - Manual (Page 1627)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Manual control
tiamo 2.4
￭￭￭￭￭￭￭￭ 1611
Moves the lift upwards for as long as this button is pressed.
Moves the lift downwards for as long as this button is pressed.
Robotic arm position
Setting the robotic arm position (angle) on the selected tower.
Current position
Shows the current position of the robotic arm in °.
Target position
Selection or entry of the robotic arm position to be approached.
Input range 0.0 - 330.0 °
Default value 0.0 °
Selection External 1 - 4
Swing rate
Swing rate for manual control of the Swing Head on the sample changer.
Input range 10 - 55 °/s
Default value 20 °/s
[Start]
Starts moving to the target position. After the start, the button changes to
[Stop], the two lower buttons are shown as disabled (gray) and Move...
is shown as status message instead of Ready.
Moves the robotic arm to the left (towards 0°) at a swing rate of 20°/s for
as long as this button is pressed.
Moves the robotic arm to the right (towards 330°) at a swing rate of 20°/
s for as long as this button is pressed.
8.4.4.4 Sample changer - Assigning a position
Program part: Manual
Here you can assign the current rack position, lift position or robotic arm
position to a specific special position.