Metrohm tiamo 2.4 Manual - Manual (Page 780)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
764 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identification Description
.EVT End volume (total dosed volume at the end of the
command) in mL
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
.FP{x}.MEA Measured value for the fixed endpoint × (1 - 9) in mV
.FP{x}.TEM Temperature for the fixed endpoint × (1 - 9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1 - 9) is reached
.FP{x}.VOL Volume for the fixed endpoint × (1 - 9) in mL
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start condi-
tions are processed) in °C
.LP.CAx Calculated value × (1 - 3) for the last measuring point
in the measuring point list
.LP.DVT dV/dt for the last measuring point in the measuring
point list (SET, STAT, DOS) or drift for the last measur-
ing point in the measuring point list in µg/min (KFC)
.LP.EXx External value × (1 - 3) for the last measuring point in
the measuring point list
.LP.MEA Measured value for the last measuring point in the
measuring point list in the unit of the measured value
of the measuring point list
.LP.TEM Temperature for the last measuring point in the mea-
suring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.VOL Volume for the last measuring point in the measuring
point list in mL
.MA.MEA Maximum measured value in the unit of the mea-
sured value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is
reached