Metrohm tiamo 2.4 Manual - Manual (Page 1040)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1024 ￭￭￭￭￭￭￭￭
tiamo 2.4
Measuring interval
Time interval for entering a measuring point in the measuring point list.
856
Input range
0.1 - 999999.0 s
Default value 2.0 s
Stop measured value
Stop when the entered measured value has been reached since the start
of the measurement.
856
Input range
0.0000 - 2000.00 mS/cm
Selection off
Default value off
off
No stop.
Measurement without drift control
If the option Measurement without drift control has been selected,
then the following parameters will be displayed:
Duration of measurement
Maximum period of time for measurement.
Input range 0 - 999999 s
Default value 120 s
Measuring interval
Time interval for entering a measuring point in the measuring point list.
Max. number of entries?
712
Input range
0.4 - 999999 s
Default value 2.0 s
856
Input range
0.1 - 999999.0 s
Default value 2.0 s
Stop measured value
Stop when the entered measured value has been reached since the start
of the measurement.
Input range 0.0000 - 2000.00 mS/cm