Metrohm tiamo 2.4 Manual - Manual (Page 1053)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1037
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Open the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 934).
[Properties]
Open the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 934).
[Delete]
Delete the external measured value selected in the table.
5.6.4.12 MEAS Ref
5.6.4.12.1 MEAS Ref - Overview
Dialog window: Method ▶ MEAS Ref ▶ Properties... ▶ MEAS Ref - 'Command
name'
Command for the measurement of the dark spectrum and the ref-
erence spectrum with an Avantes spectrometer.
Devices
This command can be executed with the following instrument:
Spectrometer: Avantes
NOTE
In a one-channel instrument setup, only instruments for which the entry
not defined is selected under Instrument for reference channel in
the configuration can be selected.
In a two-channel instrument setup, only instruments which are assigned
an instrument for the reference channel can be selected (see Chapter
7.14.3, page 1559).