Metrohm tiamo 2.4 Manual - Manual (Page 1061)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1045
End wavelength
Upper limit of the evaluation range.
Input range 100.0 - 2,000.0 nm
Default value 1,000.0 nm
5.6.4.14 MEAS Opt
5.6.4.14.1 MEAS Opt - Overview
Dialog window: Method ▶ MEAS Opt ▶ Properties... ▶ MEAS Opt - 'Command
name'
Command for the measurement of the sample solution at a defined
wavelength.
Devices
This command can be executed with the following instruments:
Spectrometer: Avantes
NOTE
In a one-channel instrument setup, only instruments for which the entry
not defined is selected under Instrument for reference channel in
the configuration can be selected.
In a two-channel instrument setup, only instruments which are assigned
an instrument for the reference channel can be selected (see Chapter
7.14.3, page 1559).
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the MEAS Opt command are set on the following
three tabs:
￭ General/Hardware
Parameters for instrument.
￭ Measuring parameters
Parameters for setting the measurement procedure.