Metrohm tiamo 2.4 Manual - Manual (Page 1234)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1218 ￭￭￭￭￭￭￭￭
tiamo 2.4
Number
Specification of the number of the rack position. This parameter is only
visible for Move = Rack position or Special beaker. The rack position
can be entered as a formula as well, which is necessary for the automatic
calibration of electrodes, for example. The formula editor is opened by
right-clicking on the input field.
Move = Rack position
Input range
1 - 999
Default value 1
Move = Special beaker (for 778, 789, 814, 815, 855, 864, 874)
Input range
1 - 16
Default value 1
Move = Special beaker (for 730)
Input range
1 - 8
Default value 1
Move = Special beaker (for 774)
Entry
1
Move angle
This parameter specifies the angle by which the sample rack should be
rotated relative to the current position. It is only visible for Move = Rela-
tive angle.
778, 789, 814, 815, 855, 864, 874
Input range
-259.90 - 259.90 °
Default value 5.00 °
Beaker test
Selection of the action to be carried out if the beaker sensor defined for
the rack does not detect any beakers at the target position. If the robotic
arm is selected as the beaker sensor, then a Swing Head must be
installed. A work position also defined in the rack data must also be
defined in such a way that a contact exists between beaker sensor and
beaker. This work position will be approached automatically for beaker
recognition after the command MOVE. This section is not visible when
Move = Relative angle.
Selection Display message | Stop determination | Stop
determination and series
Default value Display message