Metrohm tiamo 2.4 Manual - Manual (Page 1290)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1274 ￭￭￭￭￭￭￭￭
tiamo 2.4
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | RS-232 device
Default value RS-232 device
Transfer commands
The Transfer commands defined in the dialog window are sent in the
sequence in which they are listed. The table cannot be edited directly.
NOTE
10 transfer commands can be entered at maximum.
Moves the selected command up (changes the sequence).
Moves the selected command down (changes the sequence).
[New]
Opens the dialog window Transfer command for entering a new trans-
fer command (see Chapter 5.6.9.6.3, page 1275).
[Properties]
Opens the dialog window Transfer command for editing the transfer
command selected in the table (see Chapter 5.6.9.6.3, page 1275).