Metrohm tiamo 2.4 Manual - Manual (Page 846)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
830 ￭￭￭￭￭￭￭￭
tiamo 2.4
Designation Description
.FP{x}.QTY Measured value (water) for the fixed endpoint × (1…9)
in µg
.FP{x}.TEM Temperature for the fixed endpoint x (1…9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1…9) is reached
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.CHA Charge for the last measuring point of the measuring
point list in mA s
.LP.DVT dV/dt for the last measuring point on the measuring
point list (SET, STAT, DOS) or drift for the last measur-
ing point on the measuring point list in µg/min (KFC)
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.IGE Current pulsed current for the last measuring point in
the measuring point list in mA
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.QTY Measured value (water) for the last measuring point in
the measuring point list in µg
.LP.TEM Temperature for the last measuring point of the mea-
suring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.UGE Voltage at the generator electrode for last measuring
point of the measuring point list in V; in case of meas-
urements with 756, 831: 0 = not defined, 1 = <14
V, 2 = 14…28 V, 3 = >28 V
.MTE Temperature measurement with sensor; 1 = on, 0 =
off
.NMP Number of measuring points in measuring point list