Metrohm tiamo 2.4 Manual - Manual (Page 1351)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
tiamo 2.4
￭￭￭￭￭￭￭￭ 1335
NOTE
If the backup directory is on a network drive, then the date of the
backup should be added to the Backup name, because the backup
date information is not available when the data is restored.
[Start]
Starts the manual backup of the complete configuration database (includ-
ing method groups and methods).
6.3.2.3 Restoring configuration data
Dialog window: Restore configuration data
Dialog window "Restore configuration data"
Backup directory
Selection of a directory predefined in the program administration that
contains the backed-up configuration database.
Selection 'Backup directories'
Backup name
Selection of a backup file.
Selection 'Backup files'
Backup date
Shows the time at which the configuration database was backed up. This
information is not available if the backup file is located on a network
drive.
Database name
Shows the name of the configuration database. This information is not
available if the backup file is located on a network drive.
Size
Shows the size of the configuration database in KB.
Save as
Shows the name under which the configuration database will be restored.
[Start]
Starts restoration of the configuration database. After the start, a progress
bar appears in the window. The dialog window closes automatically once
the backup has been completed.