Metrohm tiamo 2.4 Manual - Manual (Page 297)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
tiamo 2.4
￭￭￭￭￭￭￭￭ 281
<sensorE0 val="" /> Electrode zero point of the sensor.
<sensorC val="" /> Blank value of the ISE sensor.
<sensorCalTemp val="" /> Calibration temperature.
<sensorCalDate val="" /> Calibration date.
<sensorCalMethod val="" /> Calibration method.
<sensorCalMeasInput val="" /> Measuring input at calibration.
</sensorData>
</Sensor>
</Device>
– <CalibData> Calibration data
<sensorName val="" /> Sensor name.
<sensorType val="" /> Sensor type.
<sensorSlope val="" /> Slope of the sensor.
<sensorPh0 val="" /> Electrode zero point of the pH sensor.
<sensorIonVa val="" /> Ion (valency) of the ISE sensor.
<sensorE0 val="" /> Electrode zero point of the sensor.
<sensorC val="" /> Blank value of the ISE sensor.
<resultUnit val="" /> Concentration unit of calibration.
<variance val="" /> Variance of calibration.
<sensorCalTemp val="" /> Calibration temperature.
<sensorCalTempType val="" /> Calibration mode.
<sensorCalDate val="" /> Calibration date.
<sensorCalMethod val="" /> Calibration method.
<sensorCalUser val="" /> User.
<sensorEltTime val="" /> Date of the electrode test.
<sensorEltResult val="" /> Result of the electrode test.
– <CalibrationTable> Calibration solutions.
– <header> Column headers.
<<RowDesc val="" /> Column header for buffers/standards.
<NominalVal val="" /> Column header for nominal value.
<MeasVal val="" /> Column header for measured value.
<CalTemp val="" /> Column header for calibration temperature.