Metrohm tiamo 2.4 Manual - Manual (Page 1306)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1290 ￭￭￭￭￭￭￭￭
tiamo 2.4
Maximum run number
on | off (Default value: on)
If this option is enabled, then the maximum number of runs will be used
as stop condition by repeat and while loops. If the maximum number of
runs is reached, the loop will be canceled at the time the LOOP command
is started again.
Input range 0 - 999
Default value 1
Maximum run time
on | off (Default value: off)
If this option is enabled, then the maximum run time will be used as stop
condition by repeat and while loops. The starting point for the run time is
the first start of the loop command, which means that the run time for
While loops is started only after the loop has been run through once. If
the maximum run time is reached, the loop will be canceled at the time
the LOOP command is started again.
Input range 0 - 999.9
Selection min | s
Default value min
NOTE
The run time is paused if the method is stopped with [HOLD].
Condition
on | off (Default value: off)
If this option is enabled, then the condition defined here will be used as
stop condition by repeat and while loops.
The input field contains the expression for the condition(s) which can be
created or edited with the formula editor after pressing on or double-
clicking in the text field (see Chapter 2.4, page 30). If the condition is ful-
filled (evaluation of the formula gives the result 1 = true), then the loop
will be canceled when the LOOP command is called.
Entry 1000 characters
Default value 'empty'