Metrohm tiamo 2.4 Manual - Manual (Page 778)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
762 ￭￭￭￭￭￭￭￭
tiamo 2.4
Titrando: 808, 809, 835, 836, 841, 842, 852, 857, 888, 901, 902, 904,
905, 906, 907
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798,
799
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
without conditioning with conditioning
Parameters
The parameters for the SET Upol command are set on the following
eight tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
￭ Control parameters
Control parameters for endpoint 1 and endpoint 2 (measured values
for the endpoints, titration rate, user-defined parameters, stop crite-
rion).
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definition of conditions which cause the titration to stop.
￭ Conditioning
Enable/disable conditioning. Definition of start drift, drift correction
and stop conditions.
￭ Additional evaluations
Definition of additional methods for the evaluation of the titration
curves.
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands, which are saved as additional columns in the measuring point
list.