Metrohm tiamo 2.4 Manual - Manual (Page 1077)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1061
Sensor
Colorimetric sensor
Selection of a colorimetric sensor from the table of colorimetric sensors.
The calibration data for the colorimetric sensor will be adopted for the
determination.
Selection 'Name of the colorimetric sensor' | empty or
'first list entry'
Default value empty or 'first list entry'
Temperature measurement
Type of temperature measurement.
Displayed only when Device type = 089 Photometer.
Selection continuous | off
Default value continuous
Stirrer
The Stirrer section is only displayed for Device type = 089 Photome-
ter.
Stirrer
Selection of the stirrer.
Selection 1 | off
Default value 1
off
Means that no stirrer will be used.
Stirring rate
Setting the stirring rate.
Input range 0 - 15
Default value 5
Switch off automatically
on | off (Default value: on)
If this check box is activated, the stirrer will be switched off automatically
when the command has finished.