Metrohm tiamo 2.4 Manual - Manual (Page 1062)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1046 ￭￭￭￭￭￭￭￭
tiamo 2.4
￭ Evaluations
Definition of evaluation results for absorbance measurements.
Command variables
The following command variables are generated by the MEAS Opt com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identification Description
.BP{#}.[MEA] Measured value for the break point (1 - 9) in the unit
of the measured value
.BP{#}.CNT Intensity for the break point x (1 - 9) in counts
.BP{#}.TEM 1) Temperature for the break point # (1 - 9) in °C
.BP{#}.TIM Time for the break point # (1 - 9) in s
.BP{#}.TRN Transmission for the break point x (1 - 9) in %
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.DBL Total duration for the processing of the command in
s
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.ETE 1) End temperature (temperature after the command
has been processed) in °C
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
.FP{#}.[MEA] Measured value for the fixed endpoint # (1 - 9) in the
unit of the measured value
.FP{#}.CNT Intensity for the fixed endpoint x (1 - 9) in counts
.FP{#}.TEM 1) Temperature for the fixed endpoint # (1 - 9) in °C
.FP{#}.TIM Time for fixed endpoint # (1 - 9) in s
.FP{#}.TRN Transmission for the fixed endpoint x (1 - 9) in %
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value