Metrohm tiamo 2.4 Manual - Manual (Page 881)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 865
Titrando: 835, 836, 842, 857, 902, 906, 907
Titrino: 718, 736, 751, 799
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the STAT pH command are set on the following eight
tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
￭ Control parameters
Parameters for the control point.
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definition of conditions which cause the titration to stop.
￭ Monitoring
Definition of the monitoring of measured value, dosing rate and tem-
perature.
￭ Evaluations
Definition of methods for evaluation of the titration curves.
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands, which are saved as additional columns in the measuring point
list.
Command variables
The following command variables are generated by the STAT pH com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':