Metrohm tiamo 2.4 Manual - Manual (Page 348)

4.5 Determination overview
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
332 ￭￭￭￭￭￭￭￭
tiamo 2.4
Input range 0.01 - 1000
Default value 0.01
Smoothing factor y-axis
Factor for smoothing on the y axis.
Input range 0.01 - 1000
Default value 0.01
Show with original curve
on | off (Default value: off)
If this check box is activated, then the original curve (solid line, same
color) will be shown in addition to the smoothed curve (dotted line).
4.5.2.6.4.6.4.4 Properties curve evaluation - y2 axis
Tab: Database ▶ Determinations ▶ Reprocess... ▶ Reprocessing ▶ Curve evalua-
tion ▶ [Edit] ▶ Curve evaluation ▶ Properties ▶ y2 axis
On the tab y2 axis the parameters for the graphical display of the curves
on the y2 axis (right y axis) can be set.
Command type
Shows the type of command for which the curve properties can be
defined. The curve properties defined for each command type for the
reprocessing window are saved per client.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be
scaled automatically. In this case the fields Start value and End value
cannot be edited.
Size
Selection Command-dependent selection | off
Default value off
Command-dependent selection
Selection of the quantity to be shown on the y2 axis.
Label
Freely definable axis label for the y2 axis.
Selection 50 characters | auto
Default value auto
auto
The designation from the field Size will be used.