Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1020)

968 Brocade Network Advisor SAN User Manual
53-1003154-01
Configuring FCIP tunnel advanced settings
22
Configuring QoS percentages
For 8 Gbps platforms, you can adjust Quality of Service (QoS) priority percentages from the preset
default values of 50 percent (High), 30 percent (Medium), and 20 percent (Low). Values for the
three priority levels must equal 100 percent. A minimum of 10 percent is required for each level.
You can adjust percentages in increments of 1 percent. To configure QoS percentages, complete
the following steps:
1. Select Advanced Settings on the Add FCIP Tunnel or Edit FCIP Tunnel dialog box to display the
Advanced Settings dialog box.
2. From the Transmission tab, click the up and down arrows by the QoS (High), QoS (Medium),
and QoS (Low) percentage values to increase and decrease values.
Configuring IPsec and IKE policies
IPsec and IKE policies are configured from the Security tab. The options and procedures are
platform-dependent.
Figure 436 on page 968 shows the Security tab for the 8 Gbps Extension
Switch and 8 Gbps Extension Blade.
1. Select Advanced Settings on the Add FCIP Tunnel or Edit FCIP Tunnel dialog box to display the
Advanced Settings dialog box.
2. Select the Security tab.
FIGURE 436 Advanced Settings Security Tab for the 8 Gbps Extension Switch and Blade
3. As an option, click Ensure connecting peer switches have known WWNs. This provides an
added measure of security.
4. Enter the WWN for the remote switch.