Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1348)

1296 Brocade Network Advisor SAN User Manual
53-1003154-01
Pseudo events
32
2. Click Add.
3. The Identification pane of the Add Pseudo Event dialog box displays.
4. Type a unique name for the pseudo event. Duplicate names are not allowed.
5. Select the Enabled check box to enable the pseudo event or clear the check box to disable the
pseudo event.
6. Click Next.
The Policy pane of the Add Pseudo Event dialog box, shown in Figure 562 , displays.
Setting pseudo event policies
The Policy pane of the Add Pseudo Event dialog box, shown in Figure 562 , allows you to create
escalation, resolve, and flapping policies for the pseudo event, and then specify the time duration
for each of these policies in minutes or seconds.
FIGURE 562 Policy pane of the Add Pseudo Event dialog box
To create policies for a pseudo event definition, complete the following steps.
1. Click the Escalation button to create an escalation policy, and then enter the duration of time
that the Management application waits before performing the specified action. Specify the
escalation time in minutes or seconds.
When an event occurs, an escalation policy waits for a duration of time to see if the event
remains in that state. If it does, then the specified action in the definition is performed.
Refer to “Adding a pseudo event on the escalation policy” on page 1300 for complete
instructions.