Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 1234
1182
Brocade Network Advisor SAN User Manual
53-1003154-01
Flow Generator
29
10. Select one of the following format options for End Device mode:
•
Port Address (port ID) — Select to display the source and destination device address using
the port ID.
•
WWN (world wide name) — Select to display the source and destination device address
using the port WWN.
11. Enter the address or WWN of the source port in the Source field or click the ellipsis button to
select a port from the list.
Enter an asterisk (*) to use any port. To select the source port from a list, refer to
end device port from a list of available device ports”
When you enter a port ID or WWN in the Source or Destination fields, a port information field
displays beneath with the port label based on your topology layout settings (refer to
on page 386"). If you enter an asterisk (*) or no value in the Source or
Destination fields, this field remains blank.
12. Enter the address or WWN of the source port in the Destination field or click the ellipsis button
to select a port from the list.
Enter an asterisk (*) to use any port. To select the destination port from a list, refer to
“Selecting an end device port from a list of available device ports”
13. (Optional) If you want to swap source and destination device port information, click <swap>.
14. Select one of the following format options for Switch mode:
•
Port (slot/port) — Select to display the switch ingress or egress port using the slot and port
number.
•
D,I (domain ID, port number) — Select to display the switch ingress or egress port using the
domain ID and port number.
15. Enter the ingress port in Port (slot/port) or D,I (domain ID,port number) format for the SIM-Port
in the Ingress field or click the ellipsis button to select a port from the list.
Enter an asterisk (*) to use any port. To select the ingress port from a list, refer to
ingress or egress port from a list of available switch ports”
NOTE
You must enter the slot number and the port number. For Backbone chassis, the slot number
cannot be 0 (zero). For switches, you must enter 0 (zero) as the slot number. For logical (virtual)
switches, follow the rule for the physical chassis (either Backbone chassis or switch) from
which you created the logical switch.
When you enter a value in the Ingress or Egress fields, a port information field displays
beneath with the port label based on your topology layout settings (refer to
on page 386"). If you enter an asterisk (*) or no value in the Ingress or Egress fields, this
field remains blank.