Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1195)

Brocade Network Advisor SAN User Manual 1143
53-1003154-01
Flow Monitor
29
15. Enter the egress port data in Port (slot/port) or D,I (domain ID,port number) format in the
Egress field or click the ellipsis button to select a port from the list.
Enter an asterisk (*) to use any port. To select the egress port from a list, refer to “Selecting an
ingress or egress port from a list of available switch ports” on page 1146".
NOTE
You must enter the slot number and the port number for the chassis, the slot number cannot
be 0 (zero). For switches, you must enter the port number without any slot number.
16. For FCR or virtual fabrics, select one of the following format options for FCR/XISL mode:
• Fabric ID — Select to configure a flow definition for a FCR fabric.
• VFID (Virtual Fabric ID) — Select to configure a flow definition for virtual fabrics.
17. For FCR or virtual fabrics, enter the fabric ID or virtual fabric ID in the Source field.
Enter an asterisk (*) to use any port. To select the source from a list, refer to “Selecting a fabric
or virtual fabric ID from a list of available products” on page 1147".
18. For FCR or virtual fabrics, enter the fabric ID or virtual fabric ID in the Destination field.
Enter an asterisk (*) to use any port. To select the destination from a list, refer to “Selecting a
fabric or virtual fabric ID from a list of available products” on page 1147".
19. (Local Flow Mirroring only) Enter the mirror port number in the Mirror field or click the ellipsis
button to select a port from the list.
Only enabled when you select the Local Flow Mirroring option for the Mirror feature. Only
supported on 16 Gbps-capable ports on devices running Fabric OS 7.3 or later.
To select a port from a list, refer to “Selecting a mirror port from a list of available ports” on
page 1148".
20. Enter a frame type in the Frame Type field or click the ellipses button select a frame type from
a list.
NOTE
You cannot combine frame type and bidirectional parameters for Mirror flows.
To select a frame type from a list, refer to “Selecting a mirror port from a list of available ports”
on page 1148".
21. Enter a LUN ID in the LUN field or click the ellipses button to select a LUN ID from the list.
NOTE
You cannot use LUN IDs for Bidirectional flows.
NOTE
You cannot combine frame type, LUN, and bidirectional parameters for learning flows.
LUN IDs can be from 0 through 65535. To select a LUN ID from a list, refer to “Selecting a LUN
ID from a list of available LUNs” on page 1149".