Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1298)

1246 Brocade Network Advisor SAN User Manual
53-1003154-01
Configuration policy manager scheduling
31
Configuration policy manager scheduling
You can schedule a configuration policy manager to run automatically. For step-by-step
instructions, refer to the following procedures:
• “Configuring a one-time configuration policy manager schedule” on page 1246
• “Configuring an hourly configuration policy manager schedule” on page 1246
• “Configuring a daily configuration policy manager schedule” on page 1246
• “Configuring a weekly configuration policy manager schedule” on page 1247
• “Configuring a monthly configuration policy manager schedule” on page 1247
Configuring a one-time configuration policy manager schedule
To configure a one-time schedule, complete the following steps.
1. Select One Time from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Click the Date list to select a date from the calendar.
4. Click OK on the Schedule Properties dialog box.
To finish configuring the configuration policy manager, return to step 6 of “Adding a
configuration policy manager” on page 1240.
Configuring an hourly configuration policy manager schedule
To configure an hourly schedule, complete the following steps.
1. Select Hourly from the Frequency list.
2. Select the minute past the hour you want deployment to run from the Minutes past the hour
list.
Where the minute value is from 00 through 59.
3. Click OK on the Schedule Properties dialog box.
To finish configuring the configuration policy manager, return to step 6 of “Adding a
configuration policy manager” on page 1240.
Configuring a daily configuration policy manager schedule
To configure a daily deployment schedule, complete the following steps.
1. Select Daily from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.