Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1107)

Brocade Network Advisor SAN User Manual 1055
53-1003154-01
FC troubleshooting
27
• Trace Route Summary — This table shows a brief summary of the trace including the
following:
 Port WWN
 Port Name
 FC Address
 Switch Name
 (Fabric OS only) Whether ping was successful (Fabric OS only)
 (Fabric OS only) Round trip time (minimum, maximum, and average)
 (Fabric OS only) Whether the device ports are in active zones.
• Forward Route — This tab shows the path taken by data packets from the port belonging to
the switch on which the trace route has been invoked (source port) to the port on the other
switch (destination port). This tab includes the following path details:
 Hop
 In Port Address
 In Port Slot/Port
 Domain ID
 Switch Name
 Out Port Address
 Out Port Slot/Port
 Bandwidth (Gb/sec)
 Cost
• (Fabric OS only) Reverse Route — This tab shows the path from the destination port to the
source port. This tab contains the same path details as the Forward Route tab.
NOTE
The reverse route may sometimes be different from the forward route.
• (Fabric OS only) FC Ping — This tab shows the minimum, maximum and average round trip
times between the selected device port WWNs and the domain controller. It details
whether the selected device port WWNs are zoned or not. It also shows the number of
frames sent to the device port, frames rejected, frames timed-out and frames received by
the device port.
• (Fabric OS only) Add Flow button — Click to launch the Add Flow Definition dialog box. For
more information about Flow Vision, refer to
“Flow Vision” on page 1125.
6. Click Close on the Trace Route Summary dialog box.
7. Click Cancel on the Trace Route dialog box.
“Confirming Fabric Device Sharing”