Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 875)

Brocade Network Advisor SAN User Manual 823
53-1003154-01
Adding target disk LUNs for encryption
20
• Encryption path table: Should be LUN/Path identified by the following:
- LUN Path Serial #
- Target Port
- Initiator Port
- Container Name
- Switch Name
- Fabric
- State
- Thin Provision LUN
- Encryption Mode
- Encrypt Existing Data
- Key ID
• Remove button: Remove s a selected entry from the table.
3. Click Add to launch the Add New Path wizard.
The Select Target Port dialog box displays. (Refer to Figure 379 .)
FIGURE 379 Select Target Port dialog box
The dialog box is used to select a target port when configuring multiple I/O paths to a disk LUN.
The dialog box contains the following information:
• Storage Array : The storage array selected from the LUN view prior to launching the Add
New Path wizard.
• Host: The host selected from the LUN view prior to launching the Add New Path wizard.
• Target Port table: Lists target ports using the following identifiers:
- Target Port
- Target Port Name
- Fabric
- Container Name