Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 680)

628 Brocade Network Advisor SAN User Manual
53-1003154-01
VLAN classifier configuration
16
3. Click the FCoE tab on the Edit Port dialog box.
The Edit Port dialog box, FCoE tab displays the following parameters:
• FCoE Map field — Displays the name of the FCoE map (read-only).
• VLAN ID list — The FCoE VLAN identifier associated with the FCoE map. The values range
from 2 through 3583, and 1002 is the default.
• DCB Map — Displays the name of the DCB map (read-only).
• Details of selected DCB Map list:
 PG - ID — Lists the priority group ID (15.0 through 15.7 and 0 through 7)
 % Bandwidth — Lists the bandwidth value for priority group IDs 0-7. The total of all
priority groups must equal 100 percent.
 Priority Flow check box — Check to enable priority-based flow control on individual
priority groups.
 CoS — Lists the Class of Service (CoS) value that corresponds to the priority group ID
rows. The CoS value must be mapped to at least one of the priority group IDs (0-7).
4. If enabled, click the Enable FCoE check box to disable the port’s membership on the FCoE
map.
5. When you have finished the configuration, click OK to launch the Deploy to Ports dialog box.
6. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box displays.
7. Click Start on the Deployment Status dialog box to save the changes to the selected devices.
VLAN classifier configuration
The Management application supports VLAN classifier management only on Fabric OS 6.3.1_dcb
and Fabric OS 7.0.0.
VLAN classifier rules are used to define specific rules for classifying untagged packets to selected
VLANs based on protocol and MAC addresses. The classified frames are then tagged with a VLAN
ID.
VLAN classifier rules can be categorized into the following areas:
• 802.1Q protocol-based classifier rules
• MAC address-based classifier rules
VLAN classifiers are created on a per-switch basis.
NOTE
The VLAN Classifiers tab on the Edit Switch dialog box displays only on switches with Fabric OS
versions 7.0.0 and later.