Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 812)

760 Brocade Network Advisor SAN User Manual
53-1003154-01
Steps for connecting to a KMIP-compliant SafeNet KeySecure
20
Adding a node to the cluster
Perform the following steps on the secondary KeySecure node when adding it to the cluster.
1. From the KeySecure Management Console, select the Device tab, then select Device
Configuration > Cluster.
The Cluster Configuration page displays. (Refer to Figure 309 .)
FIGURE 309 KeySecure Cluster Configuration page
2. Under Join Cluster, enter the cluster information that you configured for the primary KeySecure
node. (Refer to “Creating a cluster” on page 751.)
3. Enter the primary KeySecure node IP address and port number in the respective Cluster
Member IP and Port fields.
4. Enter the Cluster Key File or browse to the file location.
5. Enter the Cluster Password, then click Join.
You are returned to the Cluster Configuration page with the cluster information listed in the
Cluster Members table. (Refer to
Figure 310 .)