Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 400)

348 Brocade Network Advisor SAN User Manual
53-1003154-01
Traffic flow dashboard monitors
7
5. Select the traffic measure for the monitor in the Measure area:
For Time Series monitors, you can select more than one measure.
6. (Top N and Bottom N monitors only) Select the number of ports to include in a selected
measure by entering a number in the For Top N, Bottom N Monitors, N= text box.
Valid values are from 1 through 25. The default is 10.
7. (Top N and Bottom N monitors only) Configure the monitor to show only values greater than or
less than a specified value by completing the following steps.
a. Select the Show values check box.
b. Select greater than or less than from the list.
c. Enter a value in the field.
8. (Top N and Bottom N monitors only) Configure threshold numbers and associated colors by
completing the following steps.
Depending on the monitor type you select, you can define up to four threshold numbers in
increasing or decreasing order and up to five associated threshold colors.
(Top N and Bottom N monitors only) The decreasing order defaults are as follows: 90 and
above displays red, 75 and above displays orange, 60 and above displays yellow, and all others
display blue. The maximum values allowed are -32,768 through 32,767 for SFP power and
0 through 32,767 for all other measures.
a. (Top N and Bottom N monitors only) Select the check box.
b. Enter a number in the field.
c. Click the color square to launch the Color dialog box.
• To pick a color from a swatch, select the Swatches tab. Select a color from the display.
• To specify a color based on hue, saturation, and brightness, click the HSV tab. Specify
the hue (0 through 360 degrees), saturation (0 through 100%), value (0 through
100%), and transparency (0 through 100%).
• To specify a color based on hue, saturation, and lightness, click the HSL tab. Specify
the hue (0 through 360 degrees), saturation (0 through 100%), lightness (0 through
100%), and transparency (0 through 100%).
SCSI
•
Read Frame Count (frames)
•
Write Frame Count (frames)
•
Read Frame Rate (f/s)
•
Write Frame Rate (f/s)
•
Read Data (Bytes)
•
Write Data (Bytes)
•
Read Data Rate (Mbps)
•
Write Data Rate (Mbps)
Frame
•
Transmit Frame Count (frames)
•
Receive Frame Count (frames)
•
Transmit Frame Rate (f/s)
•
Receive Frame Rate (f/s)
•
Transmit Word Count (bytes)
•
Receive Word Count (bytes)
•
Transmit Throughput (Mbps)
•
Receive Throughput (Mbps)
•
Generator Transmit Frame Count (frames)
•
Generator Receive Frame Count (frames)
•
Mirrored Frames Count (frames)
•
Mirrored Tx Frames (frames)
•
Mirrored Rx Frames (frames)