Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 914)

862 Brocade Network Advisor SAN User Manual
53-1003154-01
Viewing time left for auto rekey
20
thin-provisioned LUNs results in an attempt by the encryption switch to overwrite data up to the size
of the logical size of the thin-provisioned LUN, rather than limiting FTE/rekeying to the size of the
physically allocated LUN size or to the data that has been written. This generally triggers the
allocation of additional blocks to the thin-provisioned LUN, using up the amount of physical disk
space that is available to the LUN and defeating the objective of using thin provisioning.
Additionally, for thin-provision capable storage products that support space reclamation based on
data pattern recognition (for example, ‘string of zeros’), the encryption of such patterns will
interfere with the space reclamation functionality of the storage and should be avoided.
Certain types of storage, including 3PAR, have been successfully tested by limiting the use of thin
provisioning to “greenfield” LUNs, or LUNs that do not have any written data yet. Rekeying
operations on these LUNs, like FTE, are also not permitted. As these limitations are not feasible for
most environments, the recommendation from Brocade is that any encrypted LUNs be fully
provisioned with disk.
Viewing time left for auto rekey
You can view the time remaining until auto rekey is no longer active for a disk LUN. The information
is expressed as the difference between the next rekey date and the current date and time, and is
measured in days, hours, and minutes.
Although you cannot make changes directly to the table, you can modify the time left using CLI. For
more information, refer to the administrator’s guide supporting your key vault management
system.
To view the time left for auto rekey, follow these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 266 on page 694.)
2. Select a group, switch, or engine from the Encryption Center Devices table for which to view the
auto rekey information, then select Group/Switch/Engine > Targets from the menu task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to Figure 376 .)
3. Select a target disk device from the table, then click LUNs.
The Encryption Target Disk LUNs dialog box displays. The time left for auto rekey information is
listed in the table. (Refer to
Figure 408 .)