Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1428)

1376 Brocade Network Advisor SAN User Manual
53-1003154-01
MAPS events
33

E-mail

SFP Marginal (Port SFP status)
• Measure Value (MAPS and Fabric Watch support) — Value of the measure when the
violation occurred.
• Units (MAPS and Fabric Watch support) — The units description of the measure value.
• Recommended Action (MAPS and Fabric Watch support) — Fabric OS recommended action
for the violation. You can wrap text in this column by right-clicking the column header and
selecting the Wrap check box.
4. Select one or more violations and click Events to launch the MAPS Violation Master Log Events
dialog box (refer to “Viewing MAPS events” on page 1376).
5. Click Close.
MAPS events
Once you configure MAPS rule violations to trigger RASLOG messages, the Management
application starts receiving SNMP traps for the MAPS rule violations. The Management application
processes the RASLOG messages by an event processor and displays them in the Master Log and
the historical graphs and monitors the same as any other events.
The event processor also receives dashboard change events in the form of traps from the switch for
all rule violations whether you configure the rule to trigger a RASLOG action or not. The
Management application uses these notifications internally to process and persist MAPS violations
information. These notifications also display in the Master Log and historical graphs and monitors
although they may not be seen in the switch RASLOG.
You can determine event severity by the event icons that display on the historical graphs and
monitors and Master Log. The following table lists the event icons that display on the historical
graphs and monitors and Master Log. For more information about events, refer to the
“Fault
Management” on page 1255.
Viewing MAPS events
MAPS events allows you to view the events that occur before and after a violation. You can display
Master Log events for all MAPS violations at the product level. Port violations display Master Log
events at the product level only.
Event Icon Description
Critical
Error
Warning
Informational