Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1345)

Brocade Network Advisor SAN User Manual 1293
53-1003154-01
Event action definitions
32
5. Change the description of the definition, if needed. You can perform this action in any of the
panes of the Add Event Action dialog box.
6. Click Finish to save the new definition.
Modifying an event action definition
CAUTION
Use caution when you modify an event action. Saving changes to an event action definition resets
the runtime information for the events in the definition.
To modify an existing event action definition, complete the following steps.
1. Select Monitor > Event Processing > Event Actions.
The Event Actions dialog box displays.
2. Select the definition that you want to edit from the Event Actions list.
3. Click Edit to display the Edit Event Action dialog box.
4. Make the changes you want to make to the definition. You can perform this action in any of the
panes of the Add Event Action dialog box.
5. Click Finish to save your definition.
Deleting an event action definition
To delete an event action definition, complete the following steps.
1. Select Monitor > Event Processing > Event Actions.
The Event Actions dialog box displays.
2. Select the definition that you want to delete from the Event Actions list.
3. Click Delete.
A message displays asking you to confirm the deletion request.
4. Click Yes to delete the definition, or No to cancel the request.
Configuring event actions for Snort messages
To configure an event action for Snort messages, complete the following steps.
1. From the Identification pane of the Add Event Action dialog box, click Next to advance to the
Events pane. See “Creating an event action definition” on page 1280 for complete instructions
on event actions.
The Events pane of the Add Event Action dialog box displays, shown in Figure 559 . Snort®
Message is the default in the Show list.