Brocade Network Advisor SAN User Manual v12.3.0 User Manual
Page 889
Brocade Network Advisor SAN User Manual
837
53-1003154-01
Tape LUN statistics
20
•
Uncompressed blocks: The number of uncompressed blocks written to tape.
•
Compressed blocks: The number of compressed blocks written to tape.
•
Uncompressed Bytes: The number of uncompressed bytes written to tape.
•
Compressed Bytes: The number of compressed bytes written to tape.
•
Host Port WWN: The WWN of the host port that is being used for the write operation.
•
A Refresh button updates the statistics on the display since the last reset.
•
A Clear button resets all statistics in the display.
4. To clear the tape LUN statistics for all member LUNs for the container, click Clear, then click
Yes to confirm.
To view statistics for specific LUNs:
1. Select a tape container, then click LUNs.
2. From the Target Tape LUNs dialog box, select the LUNs you want to monitor.
Viewing and clearing tape LUN statistics for specific tape LUNs
To view or clear statistics for tape LUNs in a container, complete these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to
2. Select a group, switch, or engine from the Encryption Center Devices table that contains the
storage device to be configured, then select Group/Switch/Engine > Targets from the menu
task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to
3. Select a tape target storage device, then click LUNs.
The Target Tape LUNs dialog box displays. (Refer to
.) A list of the configured tape
LUNs is displayed.
FIGURE 391
Target Tape LUNs dialog box