Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 709)

Brocade Network Advisor SAN User Manual 657
53-1003154-01
Layer 2 access control list management
17
5. Enter a sequence number for the ACL in the Sequence field.
6. Select Permit or Deny from the Action list.
7. In the Source list, select one of the following options:
• Any
• Host
• MAC
Selecting MAC or Host enables the Source field. Enter the source address on which the
configuration filters traffic in the Source field.
8. In the Destination Address list, select one of the following options:
• Any
• Host
• MAC
Selecting MAC or Host enables the Destination field. Enter the destination address on
which the configuration filters traffic in the Destination field.
9. Select the Count check box to enable counting.
Count specifies the number of packets filtered (allowed or denied) for the ACL rule.
10. Select the Ether Type check box to specify the Ethernet protocol.
11. In the Ether Type list, select one of the following to specify the Ethernet type being transferred
in the Ethernet frame:
• ARP — Address Resolution Protocol
• FCoE — Fibre Channel over Ethernet
• IPV4- — Internet Protocol, version 4
• Custom — Enter a custom protocol. Valid values are 1536 through 65535.
12. Click the right arrow button.
The new ACL entry displays in the ACL Entries list. To create additional ACL entries, repeat
step 5 through step 12 .
13. Click OK on the Add - Layer 2 ACL Configuration dialog box.
The new ACL displays in the ACL Entries list. To create additional ACL entries, repeat step 2
through step 13 .
14. Click OK on the Device_Name - Layer 2 ACL Configuration dialog box.
The Deploy to Products - Layer 2 ACL dialog box displays. To save the configuration, refer to
“Saving a security configuration deployment” on page 664