Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 448)

396 Brocade Network Advisor SAN User Manual
53-1003154-01
Editing a Call Home center
9
8. Enter how often you want to retry the heartbeat interval in the Retry Interval field.
The default is 10 seconds.
9. Enter the maximum number of retries in the Maximum Retries field.
The default is 3.
10. Enter the primary phone number or extension of the Call Home center in the Call Home Center
- Primary Connection field.
11. Enter the backup phone number or extension of the Call Home center in the Call Home Center
- Backup Connection field.
12. Enter the phone number or extension of the local server in the Local Server - Phone Number
field.
13. Enter the identification number of the local server in the Local Server - Server ID field.
14. Click Send Test to test the phone number.
The selected Call Home center must be enabled to test the phone number.
A faked event is generated and sent to the selected Call Home center. You must contact the
Call Home center to verify that the event was received and in the correct format.
15. Click OK to close the “Test Event Sent” message.
16. Click OK.
The Call Home dialog box displays with the Call Home center you edited highlighted in the Call
Home Centers list.
17. Click OK to close the Call Home dialog box.
Editing an e-mail Call Home center
E-mail Call Home centers are available for Brocade, IBM, NetApp, and Oracle. To edit one of these
Call Home centers, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
The Call Home dialog box displays.
2. Select the Call Home center you want to edit (Brocade E-mail, IBM E-mail, NetApp E-mail, or
Oracle E-mail) in the Call Home Centers table.
3. Click Edit Centers (beneath the Call Home Centers table).
The Configure Call Home Center dialog box displays ( Figure 171 ).