Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 171)

Brocade Network Advisor SAN User Manual 119
53-1003154-01
Software Configuration
4
8. Verify the IP address on the Server Configuration Summary screen and click Next.
9. Click Finish on the Start Server screen.
10. Click Yes on the restart server confirmation message.
11. Choose one of the following options:
• If you configured authentication to CAC, enter your PIN in the CAC PIN field.
• If you configured authentication to the local database, an external server (RADIUS, LDAP,
or TACACS+), or a switch, enter your user name and password.
The defaults are Administrator and password, respectively.
NOTE
Do not enter Domain\User_Name in the User ID field for LDAP server authentication.
12. Click Login.
13. Click OK on the Login Banner.
NOTE
When you launch the Management application or navigate to a new view, the SAN tab displays
with a gray screen over the Product List and Topology Map while data is loading.
Configuring the application to use dual network cards
Issues with Client-to-Server connectivity can be due to different reasons. Some examples are:
• The computer running the Server has more than one network interface card (NIC) installed.
• The computer running the Server is behind a firewall that performs network address
translation.
To make sure that Clients can connect to the Server, you may need to edit the IP configuration
setting in the Options dialog to manually specify the IP address that the Server should use to
communicate to its Clients.
NOTE
If your Operating System is IPv4-enabled or IPv6-enabled (dual mode), the server binds using IPv4
address by default.
NOTE
IPv6 only mode does not support server to client communication (the IPv6 address cannot be bound
to the server).
To configure the IP address to override the default RMI server host IP address, complete the
following steps.
NOTE
This configuration option replaces the -Djava.rmi.server.hostname value used in previous releases.
1. Select Server > Options.
The Options dialog box displays.
2. Select Client/Server IP in the Category list to set the IP address.