Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 871)

Brocade Network Advisor SAN User Manual 819
53-1003154-01
Configuring encryption storage targets
20
13. Review any post-configuration instructions or messages, which you can copy to a clipboard or
print for later, then click Next.
The Next Steps screen displays. (Refer to Figure 375 .) Post-configuration instructions for
installing public key certificates for the encryption switch are displayed. These instructions are
specific to the key vault type.
FIGURE 375 Next Steps screen
The Next Steps screen contains the following information:
• Important Instructions: Instructions about post-configuration tasks you must complete
after you close the wizard. For example, you must zone the physical hosts and the target
together and then you encrypt the LUNs using the Storage Device LUNs dialog box.
• Copy to Clipboard button: Saves a copy of the instructions.
• Print button: Prints the configuration.
14. Review the post-configuration instructions, which you can copy to a clipboard or print for later,
then click Finish to exit the Configure Switch Encryption wizard.