Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 520)

468 Brocade Network Advisor SAN User Manual
53-1003154-01
SMI Agent Configuration Tool
11
4. Click Apply.
NOTE
Changes on this tab take effect after the next CIMOM server restart.
NOTE
You can only restart the server using the Server Management Console (Start > Programs >
Management_Application_Name 12.X.X > Server Management Console).
If you disabled SSL, a confirmation message displays. Click Yes to continue.
5. Click Close to close the SMIA Configuration Tool dialog box.
Configuring the CIMOM Bind Network Address
NOTE
You must have SAN - SMI Operation Read and Write privileges to view or make changes on the
CIMOM tab. For more information about privileges, refer to
“User Privileges” on page 1451.
To configure the network bind address, complete the following steps.
1. Click the CIMOM tab.
2. Select a network address from the IP Configuration Bind Network Address list to which you
want to bind the CIMOM server.
The default network address is the host system name.
3. Click Apply.
NOTE
Changes on this tab take effect after the next CIMOM server restart.
NOTE
You can only restart the server using the Server Management Console (Start > Programs >
Management_Application_Name 12.X.X > Server Management Console).
4. Click Close to close the SMIA Configuration Tool dialog box.