Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 138)

86 Brocade Network Advisor SAN User Manual
53-1003154-01
SAN display settings
4
FIGURE 23 Options dialog box (SAN Display pane)
3. Click Set Up FICON Display.
Any table that contains end device descriptions move the following nine columns to the
beginning of the table: Attached Port #, FC Address, Serial #, Tag, Device Type, Model, Vendor,
Port Type, and WWN.
4. Click Apply or OK to save your work.
Resetting your display
You can reset your system to display the default display settings for all fabrics. Note that returning
to current settings after a reset may require configuring each global fabric or group setting
individually. The following table (
Table 29 ) details the settings that change with reset and the
associated default state.
Importing OUI and editing product type mapping
You can import the OUI information and assign the product type as Initiator, Target, or Default. The
latest OUI can be imported from the following site.
http://standards.ieee.org/develop/regauth/oui/oui.txt
NOTE
Discovery overrides the product type based on the OUI mapping. On Discovery, the preference is
given to switch returned value of the switch only when the OUI mapping is not available.
You can change the product type of OUI on the Product Type Mapping dialog box, and the end
devices with which have the same OUI will be overridden. When you change the product type from
Default to Initiator or Target, it will be reflected in application immediately. However, changing the
product type from Initiator or Target to Default will be reflected only when there is a change in the
name server data.