Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 808)

756 Brocade Network Advisor SAN User Manual
53-1003154-01
Steps for connecting to a KMIP-compliant SafeNet KeySecure
20
Importing a signed KAC certificate into a switch
After a KAC CSR has been submitted and signed by a CA, the signed certificate must be imported
into the switch.
NOTE
This operation can be performed only after the switch is added to the encryption group.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 266 on page 694.)
2. Select a switch from the Encryption Center Devices table, then select Switch > Import
Certificate from the menu task bar.
The Import Signed Certificate dialog box displays. (Refer to Figure 304 .)
FIGURE 304 Import Signed Certificate dialog box
3. Browse to the location where the signed certificate is stored, then click OK.
The signed certificate is stored on the switch.