Step 2, Step 8, Configuring graph – Brocade Network Advisor SAN User Manual v12.3.0 User Manual

Page 1168: Options, Configuring graph options

Advertising
background image

1116

Brocade Network Advisor SAN User Manual

53-1003154-01

SAN connection utilization

28

-

2. Click Options to launch the Graph Options dialog box. Refer to

“Configuring graph options”

on

page 1116 for instructions on using this dialog box.

3. Select the Graph or Table option to display data in graphical or tabular format.

4. Select a time range relative to the present for the display of historical data from the For list.

The options are incremental from the last 30 minutes to the last 24 hours.

5. (Historical graphs and monitors only) Select the Plot Min/Max check box to plot minimum and

maximum values along with the average data point.

The range between the minimum and maximum values will be represented in a color band
surrounding the data points. The width of the color band indicates the variation during the time
period. Note that this option is not available if you select Minimum Interval granularity.

6. (Historical graphs and monitors only) Select one of the following options from the Granularity

list to set the granularity of the data point to display on the graph:

5 minutes

30 minutes

2 hours

1 day

NOTE

The graph will not update dynamically if the granularity is 30 minutes, 2 hours, or 1 day. To
update, move from one granularity setting to another. The graph will update dynamically when
Minimum Interval is selected.

7. Select the Events check box to display advanced monitoring service (AMS) violation events

received during the chart time range.

8. (Real Time Graphs/Tables and Historical Graphs/Tables dialog boxes only) Click Save as

Widget to create a performance monitor published widget on the active dashboard. For
instructions, refer to

“Configuring a monitor from a performance graph”

on page 434.

Configuring graph options

Use the following steps to configure graph options for real time performance graph display as well
as time series monitors on the Dashboard tab.

1. Click Options on the graph.

The Graph Options dialog box displays, as shown in

Figure 491

on page 1117.

Advertising