Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 859)

Brocade Network Advisor SAN User Manual 807
53-1003154-01
Replacing an encryption engine in an encryption group
20
Replacing an encryption engine in an encryption group
To replace an encryption engine in an encryption group with another encryption engine within the
same DEK Cluster, complete the following steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 266 on page 694.)
2. Select an encryption engine from the Encryption Center Devices table, then select Engine >
Replace from the menu task bar.
The Encryption Group Properties dialog box displays with the Engine Operations tab selected.
(Refer to
Figure 365 .)
You can also display the Engine Operations tab by selecting an encryption group from the
Encryption Center Devices table, selecting Group > Properties from the menu task bar, then
selecting the Engine Operations tab.
FIGURE 365 Engine Operations tab
3. Select the engine to replace from the Engine list.
4. Select the engine to use as the replacement from the Replacement list, then click Replace.
All containers hosted by the current engine (Engine list) are replaced by the new engine
(Replacement list).