Brocade Network Advisor SAN User Manual v12.3.0 - Manual (Page 1296)

1244 Brocade Network Advisor SAN User Manual
53-1003154-01
Adding a configuration policy manager
31
• Select the Check for SNMPv3 (secure SNMP) configuration check box to check each
target to see if SNMPv3 is active for device data transmission and SNMPv1 and
SNMPv2 are not configured.
• Select the Check for MAPS action enabled (SAN only) check box to determine whether
the MAPS actions are enabled over the selected switches.
b. Click the right arrow button to move the selected checks to the Selected Checks list.
c. If you selected the Check for redundant connections to neighboring switches (SAN only)
check box, enter the minimum number of connections allowed between a switch pair in
the Minimum Connections field.
The default recommended is 2. Valid values are from 2 through 512.
d. If you selected the Check for MAPS action parameter dialog check box, you must select the
necessary actions that need to be verified in the MAPs action parameter dialog.
NOTE
You can use the All SAN Switches targets (under the Product Groups > System Product
Groups node) in the Available Switches/Routers list) for future provisioning. Select All SAN
Switches and click the right arrow button to apply this policy to all discovered switches.
The selected switches display in the Selected Switches/Routers list.
8. To set configuration policy managers for hosts, select the Host Checks tab ( Figure 532 ) and
complete the following steps.
FIGURE 532 Add Configuration Policy Manager dialog box, Hosts Checks tab